ZDMC絮凝剂工业应用研究

叙述采用两种复合配方分阶段在炼油厂净化水车间一级浮选池进行工业应用试验，并与车间现用絮凝剂PAFC进行对比，试验结果表明：PAFC20＋ZDMC5的除油效果与PAFC的相当，浮渣产生量比PAFC减少26％，药剂费用低，药剂用量少，值得推广应用。     

中水回用工程设计要点分析

通过对中水回用工程的总结分析 ,针对目前部分中水回用工程中存在的问题 ,从工程设计角度对中水水源选择、水质确定、处理工艺、安全防护等应注意的问题进行分析 ,使工程中易发生的问题在设计阶段加以解决     

气浮-生物接触氧化集成技术处理受污染水源水研究

针对受污染水源水,采用气浮-生物接触氧化集成技术进行中试研究,考察各影响因素对污染物去除效果的影响,优化工艺参数和运行条件,并进行了冬季低温运行研究.与现有生化-气浮串联工艺比较,处理受污染原水(NH3-N质量浓度为5～7 mg·L-1),集成装置能取得更好的处理效果,而且具有占地小、能耗低等优点.     

新型气浮净化技术在处理废纸造纸生产废水中的应用

采用新型气浮净化技术结合生化工艺处理废纸造纸生产废水，在进水CODcr，SS，BOD5分别为1200mg／L，800mg／L，300mg／L的情况下，出水分别为64．8mg／L，18mg／L和30mg／L。     

喷射浮选处理含油污水的研究

重点对喷射浮选处理含油污水进行了试验研究，结果表明浮选室内射流泵的没水深度对喷射选除油效果有较大的影响，并且只有在气泡量大并充满浮选室及表面相对平静的状态下，才儿得较好效果，为此，我们在浮选室内加入自制的增料，使兼并的气海重新得到分散，消耗了一部分动能，减缓了浮选室的扰动，使除在大提高，从而为研制新型高效的喷射浮选设备提供了一条新途径。     

常温硝化对炼厂浮选渣脱水性能的影响

在分析浮选渣理化性能的基础上，对新鲜浮选渣及常温硝化后的浮选渣分别进行了脱水试验研究。结果表明，浮选渣经硝化后，其脱水性能明显改善。     

基于ELM网络的污水处理COD值预报模型研究

通过对沈阳某污水处理厂的叶轮气浮法污水工艺进行研究分析,得知其过程具有多变量、非线性和时变等特性,这些特性对于处理后水质的COD值准确检测非常重要。COD值的在线检测设备通常有一定滞后,影响了现场对水质的控制和提高,为此采用ELM网络来建立COD值的预报模型,并通过MATLAB软件进行了仿真研究,仿真结果表明该模型具有较好的预报效果。     

Transformations of particles, metal elements and natural organic matter in different water treatment processes

Characterizing natural organic matter （NOM）, particles and elements in different water treatment processes can give a useful information to optimize water treatment operations. In this article, transformations of particles, metal elements and NOM in a pilot-scale water treatment plant were investigated by laser light granularity system, particle counter, glass-fiber membrane filtration, inductively coupled plasma-optical emission spectroscopy, ultra filtration and resin absorbents fractionation. The results showed that particles, NOM and trihalomethane formation precursors were removed synergistically by sequential treatment of different processes. Preozonation markedly changed the polarity and molecular weight of NOM, and it could be conducive to the following coagulation process through destabilizing particles and colloids; mid-ozonation enhanced the subsequent granular activated carbon （GAC） filtration process by decreasing molecular weight of organic matters. Coagulation-flotation and GAC were more efficient in removing fixed suspended solids and larger particles; while sand-filtration was more efficient in removing volatile suspended solids and smaller particles. Flotation performed better than sedimentation in terms of particle and NOM removal. The type of coagulant could greatly affect the performance of coagulation-flotation. Pre-hydrolyzed composite coagulant （HPAC） was superior to FeCl3 concerning the removals of hydrophobic dissolved organic carbon and volatile suspended solids. The leakages of flocs from sand-filtration and microorganisms from GAC should be mitigated to ensure the reliability of the whole treatment system.     

A study on recovery of oil from sludge containing oil using froth flotation

Induced air flotation was used to recover oil from synthetically prepared sludge containing oil. A commercial surfactant was used as the collector and frother. The effects of various parameters, namely flotation time, initial amount of oil in the feed and the amount of surfactant used on the recovery of oil were investigated. Within the range of operating conditions studied herein, the maximum oil recovery obtained was about 55%. A detailed study of flotation kinetics based on oil recovery was carried out. It showed that the process followed first-order kinetics.     

水处理工艺去除藻毒素的效果探讨

探讨了饮用水处理的各工艺过程对藻毒素的去除作用,并根据前期已进行的实验对各工艺的优化组合进行了讨论,认为以气浮代替沉淀,并附之以粉末活性炭吸附预处理可有效地去除藻毒素;对没有条件改造沉淀池的水厂可暂时采用预氯化和粉末活性炭吸附组合的工艺也可达到较好的效果;对生物预处理工艺进行适当的强化,可达到对有机物、藻类、藻毒素等物质的有效去除.